Maintenance Guide

Cobham Wireless
idDAS Installation and Maintenance Guide 00109GU Rev. 2.0
Page | 113
APOI RF Module (BTSC) Replacement 6.8.2
To replace an APOI RF module
1. Remove the suspect RF module as follows:
x Label the RF connections for that module to facilitate reconnection.
x Disconnect the RF connections to the suspect module.
x Using the T8 screw driver, loosen the 4x captive screws, and gently and evenly pull the suspect
module out by its tab (located above the bottom screws).
x Place the suspect module in the packaging of the new module.
Figure 6-13. Removing RF Modules
2. Install the new module as follows:
x Gently but firmly insert the new module in the
same slot of the suspect module and tighten the
captive screws using a torque of 078 Nm.
x Reconnect the RF cables.
3. Configure the new APOI RF module in the idDAS web GUI according to Section 6.9.5.1. No other
configuration is required.
4. Verify the BTSI DL Input and DL Output LEDs = steady green
APOI Control Module Replacement 6.8.3
This section describes how to replace a suspect APOI Control module. The replacement process includes the
following web management operations:
x Backing up the configuration of the APOI
x Configuring the APOI IP address in the new Control module
x Manually adding the APOI IP Address to the idDAS management application
x Restoring the backed up configuration to the new Control module
Where relevant, references will be made to the corresponding sections describing the implementation of
each procedure.
Label all
connected cables
Tab
2x captive
screws
2x captive
screws