Maintenance Guide

Cobham Wireless
idDAS Installation and Maintenance Guide 00109GU Rev. 2.0
Page | 120
2. To restore a configuration file:
x If the file is not uploaded in the MSDH (i.e. listed under the relevant window area - System
Backup Files and/or System Configuration files, click Upload File, browse and upload the
relevant file.
x In the relevant window area, select the file and click Load. This may take about 30 sec during
which time a blank screen will be displayed
APOI Configuration Procedures 6.9.5
This section describes the following APOI configuration procedures
x APOI BTSC configuration
x APOI IP Address configuration
x Manually adding APOI to the idDAS
6.9.5.1 A-POI BTSC Configuration
Each time a BTSC card is replaced or a new BTSC card is added, it is required to configure the new card
according to the instructions in this section.
To configure the service RF parameters
1. In the Inventory screen (Section 6.9.3), select the APOI shelf unit and click Login.
2. Enter the A-POI User Name (default = admin) and Password (default = admin)
Figure 6-22. APOI Login Dialog
3. In the displayed APOI management window, do the following:
x In the left pane, click the A-POI-xx item.
x Click the A-POI Config tab. The tabular display shows the RF modules according to their slot
position (counting from left to right).
Continued on the following page…