Maintenance Guide

Cobham Wireless
idDAS Installation and Maintenance Guide 00109GU Rev. 2.0
Page | 70
5.4.2.2 idRU-40 Fan Hood Assembly
This section describes how to assembly the fan hood onto idRU-40 repeaters.
1. Place the repeater on a flat surface with the repeater door panel facing down and the interfaces towards
you.
WARNIN
G! Be sure to start with this phase – otherwise, the assembly may be damaged.
2. Loosely assemble the mounting brackets — the position differs depending on whether this is a wall
mount or a rackmount, where Figure 5-8 shows position for wallmount:
x Align innermost bracket holes to repeater mounting holes.
x Loosely insert four bolts and washers.
Figure 5-8. Positioning Brackets
Repeater front door
(Faces downwards in the illustration)
Align brackets and loosely
insert four bolts and washers
Note: For rack-mount installations,
the bracket position
s are
inverted.
at
e