Maintenance Guide

Cobham Wireless
idDAS Installation and Maintenance Guide 00109GU Rev. 2.0
Page | 76
To mark and drill the wall
1. Plan the location on the wall of the repeaters and any other required equipment (such as the 7-band
filer/plexer for Australia if installed on the wall).
2. Using the provided template in the kit, mark out the fixing centers of the repeater and other equipment
on the chosen wall.
Figure 5-16. Template Example
3. Mark and drill the wall with the correct size masonry bit as specified by the fixing manufacturer.
NOTE: It is good practice to wear goggles to protect your eyes from flying debris when using power
tools.
4. Hold the drill bit against the mark and begin drilling slowly so that the bit does not wander from the
position. The wall should be drilled to a depth which is sufficient to accommodate the full length of the
fixing.
5. Insert the fixings so that the top of the sleeve/anchor section is level with the wall surface.