User`s guide

20
Motherboard User’s Guide
IDE Devices
f
Your computer has one IDE channel which can be installed with one or two devices
(Master and Slave). Use these items to configure each device on the IDE channel.
IDE HDD Auto-Detection [Press Enter]
IDE Channel 0 Master [Auto]
Access Mode [Auto]
Capacity 80 GB
Cylinder 38309
Head 16
Precomp 0
Landing Zone 38308
Sector 255
Item Help
Menu Level
f
f
: Move Enter: Select +/-/: Value F10: Save Esc: Exit F1: General Help
F5: Previous Values F6: Fial-Safe Defaults F7: Optimized Defaults
To auto-detect the
HDD’s size, head... on
this channel
Phonex-AwardBIOS CMOS Setup Utility
IDE Channel 0 Master
Note: If you are setting up a new hard disk drive that supports LBA mode, more
than one line will appear in the parameter box. Choose the line that lists LBA for an
LBA drive.
IDE HDD Auto-Detection
Press <Enter> while this item is highlighted to prompt the Setup Utility to auto-
matically detect and configure an IDE device on the IDE channel.
IDE Channel 0/2/3 Master & IDE Channel 0 Slave
Leave this item at Auto to enable the system to automatically detect and configure
IDE devices on the channel. If it fails to find a device, change the value to Manual and
then manually configure the drive by entering the characteristics of the drive in the
items described below.
Note: Before attempting to configure a hard disk drive, ensure that you have the
configuration information supplied by the manufacturer of your hard drive. Incor-
rect settings can result in your system not recognizing the installed hard disk.
Press <Esc> to return to the Standard CMOS Features page.
Access Mode (Auto)
This item defines ways that can be used to access IDE hard disks such as LBA
(Large Block Addressing). Leave this value at Auto and the system will automati-
cally decide the fastest way to access the hard disk drive.