User`s guide

Motherboard User’s Guide

ACPI Suspend Type

Use this item to define how your system suspends. In the default, S3 (STR), the

suspend mode is a suspend to RAM, i.e., the system shuts down with the

exception of a refresh current to the system memory.

Soft-Off by PBTN

Under ACPI (Advanced Configuration and Power management Interface) you can

create a software power down. In a software power down, the system can be

resumed by Wake Up Alarms. This item lets you install a software power down

that is controlled by the power button on your system. If the item is set to Instant-

Off, then the power button causes a software power down. If the item is set to

Delay 4 Sec. then you have to hold the power button down for four seconds to

cause a software power down

HPET Support

This item enables or disables HPET support.

Resume by PCI PME

This system can be turned off with a software command. If you enable this item,

the system can automatically resume if there is an incoming call on the PCI

Modem card or PCI LAN card. You must use an ATX power supply inorder to

use this feature. Use this item to do wake-up action if inserting the PCI card.

Power Management Setup PagePower Management Setup Page

Power Management Setup Page

This option lets you control system power management. The system has various

power-saving modes including powering down the hard disk, turning off the

video, suspending to RAM, and software power down that allows the system to

be automatically resumed by certain events.

Phonex-AwardBIOS CMOS Setup Utility

Power Management Setup

Item Help

Menu Level

ACPI Suspend Type [S3]

Soft-Off by PBTN [Instant-Off]

HPET Support [Disabled]

Resume By PCI PME [Disabled]

Resume By WOM/RING [Disabled]

Resume By USB (S3) [Disabled]

Resume By PS2 MS(S3) [Disabled]

Resume By PS2 KB(S3) [Disabled]

Power-On by Alarm [Disabled]

X Day of Month Alarm 0

Time (hh:mm:ss) Alarm 0 : 0 : 0

Power on After Power Fial [Off]

: Move Enter: Select +/-/: Value F10: Save Esc: Exit F1: General Help

F5: Previous Values F6: Fial-Safe Defaults F7: Optimized Defaults