Datasheet

20
Motherboard User’s Guide
HT Frequency (Auto)
This item enables users to manually set up the HyperTransport frequency. If
Manual, the HT Frequency Value will display, and the options are 200 MHz,
400 MHz, 600 MHz, 800 MHz and 1000 MHz.
AMD C & Q (Enabled)
This item helps the system to lower the frequency when CPU idles. When the
frequency decreases, the temperature will drop automatically as well.
Enhanced Halt (C1E) (Disabled)
This item enables or disables enhanced halt.
Quick Power on Self Test (Enabled)
Enable this item to shorten the power on testing (POST) and have your system
start up faster. You might like to enable this item after you are confident that
your system hardware is operating smoothly.
Boot Up Numlock Status (On)
This item defines if the keyboard Num Lock key is active when your system is
started.
APIC Mode (Enabled)
This item allows you to enable or disable the APCI (Advanced Programmable
Interrupt Controller) mode. APIC provides symmetric multi-processing (SMP) for
systems, allowing support for up to 60 processors.
Advanced Setup Page
This page sets up more advanced information about your system. Handle this
page with caution. Any changes can affect the operation of your computer.
The HyperTransport link
will run at this speed if it is
slower than or equal to the
system clock and the board
is capable.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Advanced Setup
HT Frequency Auto
AMD C&Q Auto
Enhanced Halt (C1E) Disabled
Quick Power on Self Test Enabled
Boot Up Numlock Status On
APIC Mode Enabled
1st Boot Device Sony Storage Media
2nd Boot Device PIONEER DVD-RM DVR-
3rd Boot Device Removable Dev.
fHard Disk Drives Press Enter
fCD/DVD Drives Press Enter
Boot Other Device Yes
Help Item
F10: Save ESC: Exit+/-/: Value
Enter : Select
F9: Optimized Defaults
F1:General Help
: Move
mnlk