User`s guide

37
Chapter 3: BIOS Setup Utility
SuperIO Device
Scroll to this item and press <Enter> to view the following screen:
Press <Esc> to return to the AwardBIOS CMOS Setup Utility page.
POWER ON Function [Hot Key]
KB Power ON Password [Enter]
Hot key Power ON [Ctrl-F12]
Onboard FDC Controller [Enabled]
Onboard Serial Port1 [3F8/IRQ4]
UART 2 Mode Controller [Disabled]
UART Mode Select [Normal]
RxD , TxD Active [Hi, Lo]
IR Transmission Delay [Enabled]
UR2 Duplex Mode [Half]
Use IR Pins [IR-Rx2Tx2]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [ECP]
ECP Mode Use DMA [3]
Power On After Power Fail [Off]
Phoenix-AwardBIOS CMOS Setup Utility
SuperIO Device
Item Help

Menu Level
POWER ON Function (Hot Key)
This feature allows you to set the method by which your system can be turned
on.
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help

F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
Onboard FDC Controller (Enabled)
Select Enabled if your system has a floppy disk controller (FDC) installed on
the system board and you wish to use it. If you install an add-in FDC or the
system has no floppy drive, select Disabled in this field.
Onboard Serial Port1 (3F8/IRQ4)
This option is used to assign the I/O address and interrupt request (IRQ) for
onboard serial port1 (COM1).
Hot Key Power On (Ctrl-F12)
When the POWER ON Function is set to Hot Key, use this item to set the hot
key combination that turns on the system.
UART 2 Mode Controller (Disabled)
This item allows users to enable or disable the onboard UART2 mode control.
KB Power ON Password (Enter)
When the POWER ON Function is set to Password, use this item to set the
passowrd.