User`s guide

Chapter 2: Motherboard Installation

JP3: Clear CMOS Jumper

Use this jumper to clear the contents of the CMOS memory. You may need to

clear the CMOS memory if the settings in the Setup Utility are incorrect and

prevent your motherboard from operating. To clear the CMOS memory,

disconnect all the power cables from the motherboard and then move the jumper

cap into the CLEAR setting for a few seconds.

Function Jumper Setting

Normal Short Pins 1-2

Clear CMOS Short Pins 2-3

Note: To avoid the system unstability after clearing CMOS, we recommend

users to enter the main BIOS setting page to “Load Optimal De-faults”

and then “Save Changes and Exit”.

Install the Motherboard

Install the motherboard in a system chassis (case). The board is a Micro ATX

size motherboard. You can install this motherboard in an ATX case. Make sure

your case has an I/O cover plate matching the ports on this motherboard.

Install the motherboard in a case. Follow the case manufacturer’s instructions to

use the hardware and internal mounting points on the chassis.

Connect the power connector from the power supply to the ATX1 connector on

the motherboard. The PJ1 is a +12V connector for CPU Vcore power.

If there is a cooling fan installed in the system chassis, connect the cable from the

cooling fan to the SYSFAN1 fan power connector on the motherboard.

Connect the case switches and indicator LEDs to the SW1 header.

SW1

ATX1

SYSFAN1

PJ1