User`s guide

Motherboard User’s Guide

Some options on the main menu page lead to tables of items with installed values

that you can use cursor arrow keys to highlight one item, and press PgUp and PgDn

keys to cycle through alternative values of that item. The other options on the main

menu page lead to dialog boxes requiring your answer OK or Cancel by selecting the

[OK] or [Cancel] key.

Standard CMOS Setup Page

This page displays a table of items defining basic information of your system.

These items set up system date and time.

Primary/Secondary/Third IDE Master/ Slave

Use these items to configure devices connected to the IDE channels. To configure

an IDE hard disk drive, choose Auto. If the Auto setting fails to find a hard disk

drive, set it to User, and then fill in the hard disk characteristics (Size, Cyls, etc.)

manually. If you have a CD-ROM drive, select the setting CDROM. If you have an

ATAPI device with removable media (e.g. a ZIP drive or an LS-120), select Floptical.

IDE BusMaster

This item enables or disables the DMA under DOS mode. We recommend you to

leave this item at the default value.

Drive A

The item defines the characteristics of any diskette drive attached to the system.

You can connect one or two diskette drives.

Press <Esc> to return to the main setting page.

If you have already changed the setup utility, press F10 to save those changes and

exit the utility. Press F1 to display a screen describing all key functions. Press F9

to load optimtimal settings.

Date & Time

Standard CMOS Setup

Date Tue 05/29/2008

Time 18:47:06

Primary IDE Master Hard Disk

Primary IDE Slave Not Detected

Secondary IDE Master Not Detected

Secondary IDE Slave Not Detected

Third IDE Master ATAPI CDROM

Third IDE Slave Not Detected

Help Item

Use [ENTER], [TAB] or

[SHIFT-TAB] to select a

field.

Use [+] or [-] to configure

system Date.

: Move Enter: Select +/-/: Value F10: Save Esc: Exit

F1: General Help F9: Load Default Settings

Drive A : 1.44 MB 3

”

IDE BusMaster Enabled