User`s guide

Chapter 3: BIOS Setup Utility

Configure DRAM Timing by SPD

When this item is set to enable, the DDR timing is configured using SPD. SPD

(Serial Presence Detect) is located on the memory modules, BIOS reads informa-

tion coded in SPD during system boot up.

VGA Share Memory

This item lets you allocate a portion of the main memory for the onboard VGA

display application.

DVMT Mode Select

This item allows you to select the DVMT operating mode.

DVMT/FIXED Memory

When set to Fixed Mode, the graphics driver will reserve a fixed portion of the

system memory as graphics memory, according to system and graphics require-

ments.

HPET

This item enables or disables HPET (High Precision Event Timer) support.

This page sets up some parameters for peripheral devices connected to the system.

Integrated Peripherals

Help Item

DISABLED: disables the

integrated IDE

Controller.

ENABLED: enables both

Controllers.

Integrated Peripherals Page

: Move Enter: Select +/-/: Value F10: Save Esc: Exit

F1: General Help F9: Load Default Settings

Onboard IDE Controller Enabled

OnBoard SATA Controller Enhanced

Onboard LAN Function Enabled

Onboard LAN Boot ROM Disabled

Onboard AUDIO Function Enabled

Serial Port1 Address 3F8/IRQ4

Parallel Port Address 378

Parallel Port Mode ECP

ECP Mode DMA Channel DMA3

Parallel Port IRQ IRQ7

USB Functions Enabled

Legacy USB Support Enabled

OnBoard IDE Controller

Use this item to enable or disable the onboard IDE interface.

Press <Esc> to return to the main menu setting page.