User`s guide

Chapter 2: Motherboard Installation

CLR_CMOS: Clear CMOS Jumper

Use this jumper to clear the contents of the CMOS memory. You may need to

clear the CMOS memory if the settings in the Setup Utility are incorrect and

prevent your motherboard from operating. To clear the CMOS memory,

disconnect all the power cables from the motherboard and then move the jumper

cap into the CLEAR setting for a few seconds.

Function Jum per Setting

Normal Short Pins 1-2

Clear CMOS Short Pins 2-3

Note: To avoid the system unstability after clearing CMOS, we recommend

users to enter the main BIOS setting page to “Load Optimal De-faults”

and then “Save Changes and Exit”.

BIOS_WP: BIOS FLASH PROTECT Jumper

Use this jumper to set the BIOS FLASH PROTECT function.

CLR_CMOS

Note: Make sure the power supply provides enough SB5V voltage before

selecting the SB5V function.

USBPWR_F2: FRONT PANEL USB POWER SELECT Jumper

USBPWR_R1: REAR USB PS/2 POWER SELECT Jumper

Use this jumper to set the Rear USB PS/2 Power function.

Functio n Jum pe r Se tting

WRITE ENA BLE OPEN

WRITE DISA BLE SHORT

USBPWR_F2

Function Jumper Setting

VCC Short Pins 1-2

5VSB Short Pins 2-3

USBPWR_R1

Function Jumper Setting

VCC Short Pins 1-2

5VSB Short Pins 2-3

BIOS_WP