User's Manual

HVM200 Manual Connecting the Accelerometer 2-5
Connecting the Accelerometer
Refer to the "Introduction" in this
manual for information on selecting
the proper accelerometer for the
HVM200 meter.
To connect the accelerometer to your HVM200 meter,
follow these steps:
Step 1 Insert the accelerometer cable into the 4-pin
connector on the HVM200 and then screw it tight.
Step 2 Insert the other end of the accelerometer cable into
the 4-pin connector on the accelerometer and then
screw it tight.
Step 3 If the HVM200 is not already turned on, press the
power button.
Step 4 Open the Setup Manager in the HVM200 App and
click the Sensor tab.
If you are using an accelerometer
with Transducer Electronid Data
Sheet (TEDS) capabilities, the
sensitivity values will already be
displayed for the x, y, and z axes of
the sensor.
FIGURE 2-7 Sensor Tab
Step 5 Click Sensor List.