User's Manual
Table Of Contents
- Introduction
- Getting Started
- Making a Measurement
- Technical Specifications
- Functions Measured
- General Characteristics
- Physical Characteristics
- Data Communication Characteristics
- Electrical Characteristics
- Adaptor Resonances and Frequency Responses
- Reference Values
- Typical Measurement Ranges
- Frequency Weighting Curves
- Fa (Flat 0.4 Hz to 100 Hz)
- Fb (Flat 0.4 Hz to 1260 Hz) Frequency Weighting
- Fc (Flat 6.3 Hz to 1260 Hz), Wh, and Wf Frequency Weighting.
- Wm, Wc, and Wd Frequency Weightings
- We, Wj, and Wk Frequency Weighting
- Wg Frequency Weighting (Defined in BS6841:1987)
- Wm (Whole Body) Frequency Weighting
- Typical Measurements Ranges
- Standards Met
- Glossary
- RMS Acceleration
- RMS Acceleration in Decibels
- Allowed Exposure Time
- Energy Equivalent RMS Acceleration
- Running RMS Acceleration LINEAR
- Running RMS Acceleration EXPONENTIAL
- Vibration Dose Value
- Maximum Transient Vibration Value
- Minimum Transient Vibration Value
- Long Term Maximum Peak
- Short Term Maximum Peak
- Long Term Crest Factor
- Short Term Crest Factor
- Summed Instantaneous Acceleration
- Regulatory Compliance Statement
HVM200 Manual Technical Specifications A-1
APPENDIX
A
Technical Specifications
Specifications are subject to change without notice. Numerical values given are typical. Refer to
specific calibration or test results for accurate data on a specific unit.
Functions Measured
General Characteristics
Real-time Clock/Calendar
• Accuracy: 0.02% (-10° C to 50° C)
• 24 hour clock: hh:mm:ss
Run-time Clock
• One second resolution
• Format: hh:mm:ss
• Maximum run time: 99:59:59
Mode Data Buffer Measurements Time History Buffer Measurements
Vibration Arms, Amin, Amax, Amp, Peak, Aeq,
PE
Arms with optional Peak
Hand Arm Arms, Amin, Amax, Amp, Peak, Aeq,
A(1), A(2), A(4), A(8), A(8) Exposure,
PE
Arms with optional Peak
Whole Body Arms, Amin, Amax, Amp, Peak, Aeq,
CFmp, CF, VDV,PE
Arms with optional Peak