Data Sheet
Industrial IoT Radio Module
2x2, 802.11ac Wave 2
COMPLIANCE
8
> pctel.com/industrial-iot-devices
6.2.1. Antenna Information
The radio transmitter (IC: 26854-RMWIFIAC2X2) was approved by Innovation, Science and Economic Development (ISED)
Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not
included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with
this device.
Le présent émetteur radio (IC: 26854-RMWIFIAC2X2) a été approuvé par Innovation, Sciences et Développement économique
Canada pour fonctionner avec les types d’antenne énumérés ci-dessous et ayant un gain admissible maximal. Les types
d’antenne no inclus dans cette liste, et don’t le gain est supérieur au gain maximal indiqué pour tout type gurant sur la liste, sont
strictement interdits pour l’exploitation de l’émmetteur.
Table 3. Approved Antennas
PCTEL Part Number Description Gain
5150 - 5850 MHz
BOA51004NM Heavy-Duty Omnidirectional Antenna 4 dBi
MPAMB24495804-RPSMA Portable Omnidirectional Antenna 4 dBi
MHODB24490507NM-IP Dual-Band High-Performance Omnidirectional Antenna 7 dBi
AEMH51PT155UFL Circuit-board-based 5 GHz horizontally ploraized monopole with 155 mm U.FL pigtail cable 4.3 dBi
AED2451PT155UFL Circuit-board-based dual-band dipole with 155 mm U.FL pigtail cable 2.8 dBi
AEMV2451PT155UFL Bent metal dual -band monopole with 155mm U.FL pigtail cable 2.4 dBi
AEPV2451PT155UFL Bent metal dual -band PIFA with 155mm U.FL pigtail cable 4.8 dBi
In addition, two antenna cables are required.
Important Note: For use as a client device, (not DFS master), the integrator can choose or specify a dierent antenna of like type
and equal or lesser gain as an antenna appearing in the above table and still maintain compliance.
Important Note: For use in a host system that is a DFS master, the minimum, net antenna gain allowed is 1.1 dBi, including all
other cable loss. Any antenna/cable combination whose gain is lower than 1.1 dBi, including all other cable loss, is not approved
for use with a DFS master device without additional testing and approval.
6.2.2. ISED (Canada) Compliance Statement
The following paragraphs must be included in any end-user documentation.
This device contains license-exempt transmitters/receivers that comply with Innovation, Science and Economic Development
Canada’s license-exempt RSSs. Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement Économic Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes:
1. L’appareil ne doit pas produire de brouillage.
2. L’appareil doit accepter tour brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.