User's Manual

2.3. Programming a Sensor

You can program the general-purpose programmable sensors of PDW

Technology. The programming method is as follows:

selection page.

5.Select a vehicle series and model such as 1 series and go to the year

selection page.

6.Select a year and go to the activation and programming page.

7.Place the sensor on the programmer. Ensure that no other sensors

exist within a range 50 cm from the programmer and that the sensor to

be activated is no more than 10 cm from the programmer.

8.Click Activate to activate the sensor and read sensor information.

9.The sensor information that is read after activation is displayed in the

dialog box on the right.

2.3.1. Programming a Single Sensor

1.Connect the programmer to the PC properly. Double-click the client

software to start it.

2.Click Brand in the upper-left corner to go to the brand selection page.

Select a brand, vehicle series and model and year, and go to the

activation and programming page.

3.Create a sensor ID. Three methods are available:

 Enter an ID manually.

Enter a new ID in the text box.

 Activate to copy an ID.

Place the original sensor on the programmer and click Activate. The

programmer obtains the sensor ID and enters it in the text box.