User's Manual

To switch between the battery voltage, tyre pressure/ temperature
display, short press the “SET” button.
3.Pressure, Temperature, Voltage Display
Alarm will sound when the monitor senses a safety issue. The
corresponding tyre position symbol will ash, accompanied by a
“beeping” sound.
4.Alarm
3
1. Ensure the sensor calibration position when positioning sensor on
the car.
2. After installation, ensure to check for leakage from the valve area.
3. Once installed as above, you are now ready to enjoy the added
safety of your TPMS unit.
4. This product is a plug-and-play device. Everything has been
preset already. Only when it is necessary, can you move to the
contents below.
5. If the display cannot continously receive the sensor signal due to
being sheilded by the vehicles, typre pressure data will ash or show
"00". On this occassion, a repeater (need to be bought
seperately) can be installed in the middle between the display and
the sensors to strengthen the sensor signal.
Remarks: