Installation Guide

6” wide GLASS PANEL KIT INSTALLATION
Attach the glass fittings to the top and bottom
ends of each glass panel.
Insert the rails into the second post. Postion and
fasten the second post in place - ensure that the post
is plumb. Secure the rails to the second post with
self-drilling screws. Repeat Steps 1-4 for each
remaining section.
Insert the rails into the first post and secure these
rails to this post with self-drilling screws. Use the
second post as temporary support - do NOT secure the
rails to the second post yet.
Slide the spacer in each rail against the first post.
Remove the temporary support post and slide a glass
panel (with fittings attached) into the rails until
touching the spacers.
Slide the next pair of spacers into the hand and base
rails. Repeat to complete the section.
8 9
Measure and mark the position of all posts and space
equally. Fasten the end post in place - ensure that the post
is plumb. Temporarily position the second post - do NOT
secure it yet. Cut the hand and base rails to fit between the
posts. Install the base rail support into the bottom channel
of the base rail. Insert a spacer into the handrail and
another spacer into the base rail.
IMPORTANT NOTICE: This kit was designed to fit perfectly in
a 6’ railing section. If your railing is shorter than 6’, you will
need to cut the spacers or remove glass panel(s) accordingly.
Distance between glass panels or glass panel and post must
never exceed 4”. The distance between a post and a glass
panel must never exceed 4”.
Always lift a glass panel by its sides.
Tempered glass is extremely fragile – do not bump the edges.
Always use protective gear including eyewear and gloves
when handling glass panels.
Spacers
Base rail
support
Base rail
Handrail
IMPORTANT
To ensure that the glass panels remain engaged in the rails, you
must install one or more base rail support(s) for each railing
section. To install the base rail support, insert it into the bottom
channel of the base rail (as shown in Step 1), slide it to the
centre position and secure it to deck surface using fasteners.