Installation Guide

Measure and mark the position of all posts and space
equally. Fasten the end post in place - ensure the post is
plumb. Temporarily position the second post - do NOT
secure it yet. Cut the hand and base rails to fit between
the posts.
Always use two people to handle glass
panels. Always lift a glass panel by its sides.
Tempered glass is extremely fragile – do not bump the
edges. Always use protective gear including eyewear and
gloves when handling glass panels.
GLASS PANEL INSTALLATION
(18” wide or greater)
Remove the plastic picket gaskets from both rails.
Cut the glass gaskets the same length as the rails
and drill 1/8" holes into the base rail glass gasket
for water drainage. Press the glass gaskets into
the rails and install the base rail support into the
bottom channel of the base rail.
Insert the rails into the posts. Postion and fasten
the second post in place - ensure that the post is plumb.
Secure the rails to the posts with self-drilling screws.
(Refer to Step 4 on Page 5.)
IMPORTANT: Ensure that the glass gaskets and the top
and bottom edges of the glass panel are well lubricated
with liquid soap before installing the glass panel. Install
the glass panel by inserting it into the handrail gasket
then lowering it into the base rail gasket.
Picket gasket
Base rail
support
Base
rail
Glass
gasket
Hand
rail
IMPORTANT: Ensure that the glass is fully seated in the
gaskets. Wash away excess soap with clean water.
Repeat Steps 1-4 for each remaining section.
6 7
Base rail
Base rail
Handrail
Handrail
IMPORTANT
To ensure that the glass panel remains engaged in the rails,
you must install one base rail support for each railing section.
To install the base rail support, insert it into the bottom
channel of the base rail (as shown in step 3), slide it to the
centre position and secure it to deck surface using fasteners.
IMPORTANT: The smaller of the two glass
gaskets goes into the Base rail.