Instructions / Assembly

GLASS FENCE INSTALLATION (hard surface only)
A: Slide the bottom rail support into the bottom
rail and move it to the center (do not fasten yet).
B: Insert bottom rail into bottom brackets and
fasten together using the 5/8" self-drilling screws
(provided). Fasten the second post to the concrete
surface (see Step 1).
C: Level the bottom rail and then fasten the
bottom brackets to the posts using 5/8"
self-drilling screws (provided).
Slide the mid brackets into the slots on
both posts but do not secure them yet.
5
3
4
Put the second post in position but do not
fasten it yet. Remove post caps and slide the
bottom brackets into the slots on the first
and second posts but do not fasten them yet.
2
1
A: Center the bottom rail support and mark the
hole for the concrete screw (provided). Use a
hammer drill with a 7/32" masonry bit to drill a 2"
deep hole in the concrete surface.
B: Use a 5/16" wrench to install the concrete screw.
!
Install the glass panel into the bottom rail glass gasket.
Install the top rail into the top brackets, ensuring
the glass panel is fully engaged in the glass gasket.
Once the top rail is installed, wash away excess
soap with clean water.
Ensure that the glass gasket and bottom edges of the
glass panel are well lubricated with liquid soap before
installing the glass panel.
!
Ensure that the glass gasket and top edges of the
glass panel are well lubricated with liquid soap
before installing the top rail.
A: Fasten both top brackets to the top rail
using the 5/8" self drilling screws (provided).
B: Secure the mid bracket plate using the
connector bolts (provided).
6
7
A: Measure and mark the position for the
top brackets on both posts.
B: Slide the top brackets into the slot on each
post and fasten with the 5/8" self-drilling
screws (provided), then replace the post caps.
On both posts, slide the mid bracket to the
center and fasten brackets into place with
the 5/8" self-drilling screws (provided).
8
9
10
Fence System
4' height
5' height
Distance ‘x’
43½"
55½"
Measure and mark the position of all posts and ensure
they are aligned. Put the first post in position.
A: Use a hammer drill with a 5/16" masonry bit to drill
four holes 3" deep through each corner of the post
base. Clean the holes.
B: Use a hammer to insert assembled concrete anchors
(provided) until washer is touching post base. Use a
7/16" wrench to tighten the nuts. Ensure post is plumb.
See LED Installation, Steps 1 and 2B
A B
Do not overtighten screws.
!
A B
A B
A
B
A
See LED Installation, Steps 3A and 3B
See LED Installation, Steps 4-6
For pool fences, the opening between a glass
panel and a post must not exceed 1¾".
x
Repeat these steps for remaining sections.
For pool fences, the opening between the bottom
rail and the ground must not exceed 2". Always
follow your local building codes.
!
Follow local codes for minimum fence height.
!
B
Always use two people to handle glass panels. Always lift a glass panel by its sides.
Tempered glass is extremely fragile – do not bump the edges. Always use protective gear
including eyewear and gloves when handling glass panels.
WARNING
C
This symbol indicates important information
Maximum post spacing: 3’ 11
5
/
8
" on center
!
Second post
First post