User Manual

6.3. Measuring Resistance

WARNING!

* Never connect the test leads to a source of voltage when

you have the selected the OHMS function and plugged

the test leads into the V//Hz-terminal.

* Be sure that the circuit under test has all power removed

and that any associated capacitors are fully discharged

before you make a resistance measurement.

1. Set the rotary selector to the desired OHM function.

2. Plug the black test lead into your meter’s COM terminal

and the red test lead into your meter’s V//Hz-terminal.

3. Connect the test leads to the

device you want to measure

and read the measurement

value.

4. Remove all test leads after the

measurement.

Notes:

* When you short the test leads in the 200 range, your

meter displays a small value (no more than 0.3). This

value is due to your meter’s and test leads internal

resistance. Press REL to subtract it from small resistance

measurements for better accuracy.

 Always take care of a good connection, as a bad

connection influences the resistance measurement.