User Manual

111
5. Advanced User Guidebook
Up till now, you have already been familiar with the basic operations of the function
areas, buttons and knobs in the front panel of the oscilloscope. Based the
introduction of the previous Chapter, the user should have an initial knowledge of
the determination of the change of the oscilloscope setting through observing the
status bar. If you have not been familiar with the above-mentioned operations and
methods yet, we advise you to read the section of Chapter 4 "Junior User
Guidebook".
This chapter will deal with the following topics mainly:
 How to Set the Vertical System
 Use Mathematical Manipulation Function
 How to Set the Horizontal System
 How to Set the Trigger System
 How to Implement the Sampling Setup
 How to Set the Display System
 How to Save and Recall
 How to Implement the Auxiliary System Function Setting
 How to Implement the Automatic Measurement
 How to Implement the Cursor Measurement
 How to Use Autoscale function
 How to Use Executive Buttons
It is recommended that you read this chapter carefully to get acquainted the
various measurement functions and other operation methods of the Touchscreen
series oscilloscope.