User Manual

ManualsBrandsPeakTech ManualsBenchtop OscilloscopesOscilloscope, 4x 200MHz, 2GSPS

131

132

133

134

135

136

137

138

139

140

132

multiple reference waveforms at the same time.

4. When the reference waveform is ON, you can select Vertical in the right

menu; select repeatedly to make the

symbol in front of div, turn the

G knob to adjust the vertical position; then select to make the

symbol

in front of the V/div below, turn the G knob to adjust the voltage division.

Select Horizontal in the right menu; do the same operations as above to

set the horizontal position and time base.

5. Select Ref detail in the right menu, a window will pop up to show the

sample rate and sample length.

6. Select Save to file in the right menu to save current reference waveform

to internal/external storage. See the step 6 of "To save waveform data to

reference waveform/storage" on P130.

To recall waveform data in storage

1. Press the Save button.

2. Select Recall in the bottom menu; select Recall Waveform.

3. Select the waveform file in file explorer (*.csv/*.bin), see "To select the

path or file in file explorer" on P132.

4. Select the reference waveform that you want to load to in the right menu.

5. Operate the selected reference waveform, see "To display/remove

reference waveforms" on P131.

To recall setup files

Setup files can be recalled from one of 15 internal locations or from

internal/external storage.

1. Press the Save button.

2. Select Recall in the bottom menu; select Recall Setup.

3. Select From in the right menu; in the left menu, select one of 15 internal

locations, or select File to recall from internal/external storage.

4. If you select one from Set1～Set15, select OK Load in the right menu.

5. If you select File, select File detail to enter the file explorer. Select the

setup file in file explorer (*.set), see "To select the path or file in file

explorer" on P132. Select Recover Setup in the right menu.

To select the path or file in file explorer

Introduction of the drive letters

D: Internal storage

E/F etc.: The USB ﬂash drive plugged into the USB port of the oscilloscope

In file explorer, you can use touchscreen or the G knob to select the storage,