User Manual

136
should be executed to obtain the highest level of accuracy.
Before performing a self-calibration, disconnect all probes or wires from the
input connector. Press the "Utility" button, select Calibrate in the left menu,
select Self Calibrate in the bottom menu. A confirmation window will pop up,
select OK after everything is ready.
● Pass/Fail
The Pass/Fail function monitors changes of signals and output pass or fail
signals by comparing the input signal that is within the pre-defined mask.
Press the Utility button and select Pass/Fail in the left menu.
The description of Pass/Fail Menu is shown as the follows:
Pass/Fail test:
Detect whether the input signal is within the limits of the rule, if it exceeds limits
of the rule, it is "Fail"; otherwise it is "Pass". Also it can output fail or pass
signal by built-in and configurable output port. To run the test, read the
following steps:
1. Press the Utility button, select Pass/Fail in the left menu.
2. Enable switch on: select Operator in the bottom menu, set Enable as ON
in the right menu.
3. Create rule: select Rule in the bottom menu. Select Source in the right
menu; select the desired source in the left menu. Select Horizontal or
Vertical in the right menu; turn the G knob to set Horizontal or Vertical
tolerance. Select Create in the right menu.
4. Set output type: Select Output in the bottom menu. Choose any one or
Function Menu
Setting
Description
Operator
Enable
Operator
Control enable switch
Control operate switch
Output
Pass
Fail
Ring
Info
Signal tested corresponds with the rule
Signal tested not correspond with the rule
Ring when it satisfies the rule
Control the display status of info frame on the top left
Rule
Source
Horizontal
Vertical
Create
Select source ①,②,③,④ or Math
Change the Horizontal tolerance value by turning the G
knob
Change the Vertical tolerance value by turning the G knob
Use the rule set as testing rule
Save rule
Save
Recall
Save the rule to internal/external storage
Recall a rule from internal/external storage as the testing
rule