User Manual

137
two of the options "Pass", "Fail" or "Ring". "Pass" and "Fail" are mutually
exclusive options, which could not be chosen simultaneously.
5. Begin to test: Select Operator in the bottom menu. Select Operator as
Start in the right menu, the test will begin.
6. Save rule: Select Save rule in the bottom menu. Select Save in the right
menu to enter file explorer. The path and file name are shown in the Save
To: line in the bottom. Select the save location, see "To select the path or
file in file explorer" on P132. If you want to customize the file name, select
Edit Filename in the right menu, see "To edit file names" on P133. Select
OK Save in the right menu.
7. Recall rule: Select Save rule in the bottom menu. Select Recall in the right
menu to enter file explorer. Select rule file(*.PF), see "To select the path or
file in file explorer" on P132. Select the channel that you want to load to in
the right menu.
Figure 0-6 Pass/Fail test
Note:
3. When Pass/Fail is ON, if you enter XY mode, Pass/Fail will be closed; in the
XY mode, Pass/Fail menu is disabled.
4. Under the status of stop, data comparing will stop, and when it goes on
running, the number of Pass/Fail will increase from the former number, not
from zero.
● Sync Output
Press the Utility button and select Sync Output in the left menu.
The description of Sync Output menu is shown as the follows:
Function
Menu
Setting
Description
Type
Trig level
Pass/Fail
Output trig signal synchronously
Output High Level when Pass , and Low Level when
Fail