User Manual

95
Rear Panel
Figure 0-2 Rear Panel
1. USB Host port: It is used to transfer data when external USB equipment
connects to the oscilloscope regarded as "host device". For example:
upgrading software by USB flash disk needs to use this port.
2. USB Device port: It is used to transfer data when external USB equipment
connects to the oscilloscope regarded as "slave device". For example: to use
this port when connect PC to the oscilloscope by USB.
3. VGA port: To connect the oscilloscope with a monitor or a projector as VGA
output.
4. LAN port: the network port which can be used to connect with PC.
5. The port of trigger signal output & Pass/Fail output
6. AC power input jack
7. Handle