Datasheet

4.Advanced User Guidebook
78
4. Under the status of stop, data comparing will stop, and when it goes on running,
the number of Pass/Fail will increase from the former number, not from zero.
5. When the waveform playback mode is on, Pass/Fail is used to test the
played-back waveform specially.
● Output
Push the Utility button, select Function in the bottom menu, select Output in the left
menu.
Output menu item in the bottom menu sets the output type of Trig Out(P/F) port on
Rear Panel. In the bottom menu, select Output. The description of Output menu is
shown as the follows:
VGA menu item in the bottom menu sets the output of VGA port. Connect the VGA
port to an external monitor or projector. Turn on the VGA port in this menu, the
oscilloscope display can be shown on an external monitor or projector.
Device and Print Setup menu items set the print output, refer to "How to Print the
Screen Image" on page 91.
● LAN Set
Using the LAN port or Wi-Fi, the oscilloscope can be connected with a computer. The
oscilloscope also supports communications with Android based smart device via
Wi-Fi. Refer to "Communication with PC" on page 107 and "Communication with
Android Device via Wi-Fi (Optional)" on page 115 for the operation steps.
● Update
Use the front-panel USB port to update your instrument firmware using a USB
memory device. Refer to "How to Update your Instrument Firmware" on page 78.
● DAQ
You can use the multimeter data recorder to record the measurements when
measuring current/voltage by multimeter. Refer to "Multimeter Recorder" on page
104.
How to Update your Instrument Firmware
Use the front-panel USB port to update your instrument firmware using a USB
Function
Menu
Setting Description
Type
Trig level
Output trig signal synchronously
Pass/fail
Output High Level when Pass , and Low Level when Fail
AG
Output
CH2 Output of dual-channel waveform generator
(optional)