Datasheet

5.Use the Arbitrary Function Generator (Optional)
78
 Use the touchscreen (Touchscreen is optional):
Click to increase the
value of cursor position
Move the cursor
Click to decrease the
value of cursor position
To Set the Period
Select Period in the right menu (if Period is not displayed, select Frequency and select it
again to switch to Period). Set the parameter in the right menu.
To Set the Amplitude
Select Amplitude in the right menu (if Amplitude is not displayed, select High Level and
select it again to switch to Amplitude). Set the parameter in the right menu.
To Set the Offset
Select Offset in the right menu (if Offset is not displayed, select Low Level and select it
again to switch to Offset). Set the parameter in the right menu.
To Set the High Level
Select High Level in the right menu (if High Level is not displayed, select Amplitude
and select it again to switch to High Level). Set the parameter in the right menu.
To Set the Low Level
Select Low Level in the right menu (if Low Level is not displayed, select Offset and
select it again to switch to Low Level). Set the parameter in the right menu.
To Output Square Signals
The parameters of Square waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level.
To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to To
Output Sine Signals on page 77.
To Output Ramp Signals
The parameters of Ramp waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level, Symmetry.
To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to To