Datasheet

6.Use the Multimeter (Optional)
88
(1) Select Configure in the bottom menu, select Show Info in the right menu as ON. The
information window will be shown on the display.
(2) Select OFF to hide.
Auto or Manual Range
Auto range is set as default. To switch auto or manual range, do the following steps:
(1) Select Configure in the bottom menu, select Mode in the right menu as Manu.
MANUAL will be shown on the display.
(2) Select Auto to enter auto range, AUTO will be shown on the display.
Note: When measuring capacitance, manual range is disabled.
Making Relative Measurements
When making relative measurements, reading is the difference between a stored reference
value and the input signal.
(1) Select Configure in the bottom menu, select Relative in the right menu to enter the
relative mode.
The measurement value at this time is stored as the reference value, and displayed
behind △.
In this mode, current reading = input value - reference value.
(2) Press it again to exit the mode.
Note: This function is not available when measuring resistance, diodes, and testing for
continuity.