User Manual

10.3 OLP: Over Load Protection
Normally the overload protection is sustained by the CC constant current mode.
When the CC mode fails and goes undetected, it may cause serious damage to your test piece
or load.
The OLP is to minimize the extent of damage to your loads as power supplies do fail some
day.
Switch off your power supply as soon as you see this warning as shown below.
To reset this warning, switch off the unit and remove all loading.
Switch the unit back on again and double check with caution.
If this problem cannot be fixed, please contact and consult with your agent.
All rights, also for translation, reprinting and copy of this manual or parts are reserved.
Reproduction of all kinds (photocopy, microfilm or other) only by written permission of the
publisher. This manual considers the latest technical knowing. Technical changing which are in
the interest of progress reserved.
We herewith confirm, that the units are calibrated by the factory according to the specifications
as per the technical specifications. We recommend to calibrate the unit again, after one year.
© PeakTech
®
03/2013/Pt./Ba.
PeakTech Prüf- und Messtechnik GmbH - Kornkamp 32 –DE-22926 Ahrensburg / Germany
[phone]/44 [phone]
 [e-mail]  www.peaktech.de