User Manual

: Indicates the battery power is

weakening

: Beeper tone indicator for tolerance

mode

MKΩ: Resistance (Ohm) annunciator

µmH: Inductance (Henry) annunciator

mµnpF: Capacitance (Fara) annunciator

(1) Auto Power-Off

If unused for about 10 minutes, the meter will power-down

automatically. Press Power-button switches to resume power-on

mode. When the power is down, press Power-button to turn on the

meter. The operating condition return to what they were before the

power was last turned off. In the MIN MAX record mode, RS-232

communication mode or using DC power adapter auto-power down

function is disabled automatically.

Continuous Measurement

In the power down mode, push Power-button 2 sec. Until the APO

OFF annunciator appears. Will put the meter into the continuous

measurement mode.

Power Switch

The Power-button turns the meter on or off. In the micro-computer

failure status press Power-button until the meter off.

(2) Frequency Select

Set the "FREQ"-button switch to 120 Hz or 1 kHz according to the

specimen to be test. Generally, the electrolytic capacitor is set to

120 Hz. Others are set to 1 kHz general.

(3) Parallel / Series mode

Set the "PAL SER" button switch to parallel or series measuring

circuit mode.

However, in the specimen having a high impedance in general,

measurement is made in parallel equivalent circuit mode "PAL",

while in the specimen having a low impedance, measurement is

made in series equivalent circuit mode "SER".

-39-