User Manual
(4) Range Button
Press RANGE-button to select the manual range mode and turn off
the "AUTO" annunciator (The meter remains in the range it was in
when manual ranging was selected).
In the Manual Range Mode. Each time you press RANGE-button,
the range (and the input range annunciator) increments, and a new
value is displayed. To exit the Manual Range mode and return to
autoranging, press and hold down RANGE-button for 2 seconds.
The "AUTO" annunciator turns back on.
(5) L/C/R-Function Button (only Main Display)
The L/C/R key switches the measurement parameter in sequence
L-C-R-L…, and annunciator is indicated on LCD. When the meter is
turned on, it is set to the measurement parameter selected, that
was in use, when the meter was last turned off.
(6) Q/D/R Function Button (only Secondary Display)
The Q/D/R key switches the measurement parameter in sequence
Q-D-R-Q…, the annunciator is indicated on LCD. When the meter is
turned on, it is set to measurement para-meter selected, that was
used, when the meter was last turned off.
(7) HOLD.
>2 sec.
Press the "HOLD" key to enter the data-hold mode, the "HOLD"
annunciator is displayed. When Hold-mode is selected, the meter
stops all further measurements. Press "HOLD" 2 sec. to start backlit
function, press this key for 2 sec. to exit the backlit function. After
starting the backlit for 1 minute, the backlit function will exit by
itselves.
(8) MIN/MAX-button
Press "MIN/MAX" to enter the Min/Max/Avg mode and stop the auto
shut down function. In addition to power and hold key, the other
keys cannot be activated. When the meter samples about 6 times,
and then beeper will emit a sound. When a new Max/Min data being
recorded and then beeper will emit 2 sounds. Main Display value
(second display value) cycles through (Min/Max key) present value
(parameter value) → Max value (parameter value) → Min value
(parameter value) → Max value minus Min value (times to test) →
The average value´s display (time to test). The meter will ignore and
not record if overload
-40-