User Manual

modifications. When you input + TOL setting value, the
annunciator "TOL" "▲" are flashing. The previous setting + TOL
will also appear and lets user to do the modifications. When you
input –TOL setting value, the annunciators "TOL" "▼" are
flashing. The previous setting – TOL will also appear and lets
user to do the modifications.
7. REL-setting:
Press "REL", LCD shows ∆ flashing. The previous standard
setting value will also appear and lets user to do the
modification.
8. Data-setting:
When using the character on the nameplate to input data, the
previous setting will appear and the place, that waits to be
entered will flash. INPUT starts from the largest digit to enter, if
the largest digit only 1, the original setting will flash. Press "1" is
1, press any key is 0, press "ENTER" to exit without change.
TOL Hi/Lo limits setting without largest digit.
There is no annunciator flashing after entering 5 digits, in the
meantime enters +/- symbols, press "0" to change +/- symbols,
press other keys to input + symbols.
* CAUTION!
Press "ENTER", emit 2 beeps, the data store in volatile storage.
The data will store in non-volatile storage region while the meter
power is off. In this mode the automatic power-off feather is
disabled.
(10) REL Relative Mode (only Main Display)
Press "REL" key to the Relative mode. The displayed reading is
stored as a reference value, the display is zeroed and annunciator
"∆" is displayed. Press REL key again to exit the Relative mode.
For example: The displayed reading is 100.0, then press REL to
store as a reference value and the display becomes zero, to store
100.0 as a reference value, if our input signal is 99.5, then the
reading will be 99.5-100.0 that equals –0.5.
The user (see "SET" in this manual) can also set the relative value.
When the desired relative value has been entered, press REL key
to enter the relative mode and press SET key to use Relative
values as a reference value. Press REL again to exit the relative
mode.
-42-