User Manual

4. Memory Call Button Operation
The PeakTech
®
2795 can store up to 10 measurements. To store
a value please press the MEM-key while measuring with the
MEAS-key at the same time. The memory number will be
displayed (DATA 0 … 9).
To recall the stored values please press the MEM-key. You can
switch the stored measurement values (DATA 0 … DATA 9) by
pressing the MEM-key.
If measuring a frequency (RPM,rpm,Hz) Max, Min and Average
values of this measurement will be stored additionally. For range
measurements (M/M, Y/M, I/M, F/M) Max, Min and Average
values of this measurement will be stored additionally which can
be converted to other measurement units (example: M/M in Y/M).
The revolution counting (REV) can‘t be converted and also no
additional values (Min,Max,Avg) will be stored.
Chart of the saved values:
Mode Memory values
rpm Max/Min/Avg
RPM Max/Min/Avg
M/M Max/Min/Avg: Y/M, I/M, F/M
Y/M Max/Min/Avg: M/M, I/M, F/M
I/M Max/Min/Avg: M/M, Y/M, F/M
F/M Max/Min/Avg: M/M, Y/M, I/M
Mode Memory values
REV REV Endwert
M Yd,In,Ft
Yd M,In,Ft
In M,Yd,Ft
Ft M,Yd,In
-20-