User Manual

5.2. Replacement of the fuse
WARNING!
To avoid electric shock, disconnect all the test probes before
removing the fuse. Replace only with the same type of fuse. Not
note remove the top cover. Service should be performed only by
qualified personnel.
CAUTION!
For continued protection against fire or other hazard, replace only
with fuse of the specified voltage and current ratings.
Follow these steps to replace the fuse:
1. Disconnect all the test probes.
2. Remove the protecting holster and then remove the back
cover by unscrewing the four screws and pulling off the
meter’s cover.
3. Remove the blown fuse.
4. Install the new fuse in the fuse compartment with same type
and dimensions.
5. Replace the cover and secure it with the screws.
Specifications of fuse:
0,5 A / 500 V FF; 6,3x32mm
10 A / 500 V FF; 6,3x32mm
WARNING!
Do not operate your meter until the back cover is in place and fully
closed.
-39-