User Manual

3. Press SELECT to switch between / and
°
)))
4. Remove power from the circuit.
5. Connect the test leads to the circuit.
Note:
The buzzer sounds if the measured resistance is below about 75
 approximately.
Warning! Never perform a continuity measurement on a circuit
that has power connected.
6.6. Measuring Logic Frequency
Warning! If you try to measure the frequency of a signal that
exceeds 250 V AC
rms
, you might damage your meter and expose
yourself to a severe shock hazard.
Follow these steps to measure the frequency of a signal
1. Set the rotary selector to Hz.
3. Connect the test leads to the frequency source.
6.6.1 Linear frequency measurement
Proceed to measure Sine-/Grid frequencies as follows:
1. Turn function- / range switch in position in V~.
2. Connect the red test lead to the V/Ω/Hz/- ►I input and black
test lead to COM.
3. Check applied voltage rating.
4. Press the Hz /% -button.
5. Read measured frequency value in the display.
-48-