User Manual

11. Replacing the fuses
Warning:
To avoid electric shock, disconnect the test leads from any source of
voltage before removing the back cover or the battery/fuse door.
1. Turn the screw on the battery compartment half a turn counter-
clockwise to open the battery compartment.
2. Remove the 4 housing screws of the device and remove the
back cover.
3. Remove the blown fuse from the fuse holder.
4. Insert the new fuse into the fuse holder - appropriate to the value
and the dimensions of the original fuse. Make sure that the fuse
is centred in the holder.
5. After replacing the appropriate backup, Back cover replace it
again on unit and secure it with the four screws, then Replace
the battery cover back onto the device and secure it by turning
the screw by half a turn clockwise
Warning:
To avoid electric shock, do not operate your meter until the back
cover and the battery door is in place and fastened securely
Note:
If your meter does not work properly, check the fuses and battery to
make sure that they are still good and properly inserted.
800mA/1000V F (fast acting) 6,3 x 32mm
10 A/1000V F (fast acting) 10 x 38 mm
-112-