User Manual

5.) MAX/MIN-button
Press this button, the meter enters the MAX mode, and the
LCD shows “MAX” as an indicator, the present reading on
the LCD is the maximum reading of all readings taken since
the mode and the LCD shows “MIN” as an indicator, the
present reading on the LCD is the minimum reading of all
readings taken since the
mode was activated. Press and hold down this button for
about 2 seconds to exit MAX and MIN modes.
6.) Function/Range switch
It can be used to select the desired function and range as
will as to turn on or off the meter.
To preserve battery life, set this switch to the “OFF” position
if you don´t use the meter.
7.) “10 A” jack
Plug-in connector for the red test lead for current (600mA ~
10A) measurement.
8.) “µA/mA” jack
Plug-in connector for the red test lead for current (< 600 mA)
measurements. It is also a plug-in connector for the positive
plug of the thermocouple for temperature measurements.
9.) “COM” jack
Plug-in connector for the black test lead for all
measurements. It is also a plug-in connector for the negative
plug of the thermocouple for temperature measurements.
10.) “V/Ω/Hz/ ” jack
Plug-in connector for the red test lead for all measurements
except current measurements and temperature
measurement modes.
-59-