User's Manual

English

Important:

Batteries shall not be exposed to excessive heat such as sunshine, ﬁre or the like. Remove batteries when

the remote control is not to be used for a long time. Batteries left in equipment may cause damage through

deterioration and corrosive leakage, invalidating the guarantee.

To protect the environment use local recycling facilities for battery disposal. Dispose of used batteries

according to the instructions.

CAUTION: Risk of explosion if batteries are replaced by an incorrect type. Replace only with the same or

equivalent type recommended by the equipment manufacturer.

If the batteries in your remote control are run down, you can use the buttons on your TV set. In TV mode,

they have the same functions as the corresponding buttons on the remote control. The OK button on the TV

set can be pressed repeatedly to select the required source. In the menus they have the following functions:

For models with OK button on the set: For models without OK button on the set:

PR+ or PR

▲

PR+ or PR

▲

►

PR- or PR

▼

PR- or PR

▼

◄ &

VOL+,

+ or VOL

►

VOL+, + or VOL

►

▲

VOL-, - or VOL

◄

VOL-, - or VOL

◄

▼

MENU or MENU MENU or MENU

OK OK

Getting started

Switch the TV on and off

1. When the power cord is connected, the TV will be turned on directly or be in standby mode. If the TV is in

standby mode, press the

or POWER/ button on the set or the button on the remote control to turn it

on.

2. To put the TV into standby mode, press the or POWER/ button on the set or the button on the

remote control. The TV set remains powered up, but with low energy consumption.

3. To switch the TV off, unplug the mains plug from the mains outlet.

(*On certain models, you have to turn on the power switch ﬁrst.)