Instructions / Assembly

Table Of Contents

Adjustable Mantel Assembly Instruction:

1. Hardware lists:

*Allen screw bolt (50mm), washer and nut = 4 sets

- for use in fastening the mantel shelf to the mantel legs

*Allen screws (30mm) = 18 pcs packed in a packet

- for use in securing the Plinth blocks to the bottom of each leg

*Allen key = 1 pc

- for use tightening the allen head bolts and screws

*Wrench = 1 pc.

- for use in tightening the bolts

*Adjustable 2 piece hanger board

*Adjustable 2 piece horizontal scribe

*2pcs Metal plate and 8 Phillips head screws packed in a packet

-for use in connecting the adjustable hanger board and horizontal scribe

2. Put the main shelf on the ﬂoor, upside down and attach the mantel

corresponding to the “R” and “L” markings to the shelf. Hook and snap

on to lock. Adjust the front and side to ﬂush and bolt-in.

hook on

snap-on

to lock

bolt-in left

and right

mantels

3. Determine the correct interior height and interior width based on the

building codes and the manufacturer’s instruction for your speciﬁc

ﬁreplace insert or stove. Consult a professional.

4. Adjust your interior height (based on #3) using the Plinth blocks.

Place one Plinth over the bottom of each leg and move the legs

up to the desired height. Secure the legs in place with the 30mm

screws (provided) by aligning the pre-drilled holes in the legs to

those in the Plinth blocks. Alignment is important so as not to

push the screws through the front of the leg. There are 18 x 30mm

screws provided and we suggest 9 on each leg.

If no interior height adjustment is needed, the Plinth blocks may

be left oﬀ or used as decorative pieces at the bottom of each leg.

PAGE 1
Adjustable Mantel Assembly Instruction: 1. Hardware lists: *Allen screw bolt (50mm), washer and nut = 4 sets - for use in fastening the mantel shelf to the mantel legs *Allen screws (30mm) = 18 pcs packed in a packet - for use in securing the Plinth blocks to the bottom of each leg *Allen key = 1 pc - for use tightening the allen head bolts and screws *Wrench = 1 pc.
PAGE 2
Adjustable Mantel Assembly Instruction: screw in Adjustable “Plinth” 5. Your 2 piece hanger board is designed to be completely adjustable based on the interior width determined from #3. Cut hanger boards on the routed ends and in equal lengths to meet your desired total length. Connect the pieces using the metal plate and 4 screws. cut on these ends x x x x 6. Before mounting the hanger board, see #10 below: “Installation for Mantels and Shelves using the Hanger Board” 7.
PAGE 3
Adjustable Mantel Assembly Instruction: 8. Scribe moldings - measure the inside width and height. The horizontal scribe is designed to be completely adjustable based on the needed interior width. Cut scribe boards in the routed ends and in equal lengths to meet your desired total length. Connect the pieces using the metal plate and 4 screws. Measure the inside height and cut the vertical scribes on the ﬂat end so that they miter to the top horizontal scribe.