User Manual

Connecting Power
WARNING! Before connecting power make sure the power switch is
in the OFF position.
Connecting Media Playback Sources
The Escort powered mixer will accept various media playback devices. For
connecting a CD player or grounded record player use the CHANNEL 8 RCA Left
and Right connections. For connecting an MP3 player or smartphone with media
playback use the 3.5mm stereo connector. This will require a stereo 3.5 mm cable
(03007820) which can be found at your local Peavey dealer. When using a USB
memory stick with MP3 or other audio les stored on it, insert the memory stick
into the USB connector on CHANNEL 9, make sure the USB/Bluetooth
®
button
is in the USB postition, and use the screen and controls in the master section to
navigate and play back audio les(Fig.9). Bluetooth connectivity is covered later in
the manual under the MEDIA section.
Connect the IEC power cord to the receptacle on the back panel of the unit
as shown (Fig.10), and then to a suitable electrical outlet. If an extension
cord is required, make sure it is a three-wire cord with an intact ground pin
to preserve the safety ground.
NOTE: FOR UK ONLY
As the colours of the wires in the mains lead of this apparatus may not correspond
with the coloured markings identifying the terminals in your plug, proceed as follows:
(1) The wire that is coloured green and yellow must be connected to the terminal
that is marked by the letter E, or by the Earth symbol, or coloured green or green and
yellow. (2) The wire that is coloured blue must be connected to the terminal that is
marked with the letter N, or the colour black. (3) The wire that is coloured brown must
be connected to the terminal marked with the letter L, or the colour red.
Setting Controls and Turning Unit On
Before turning on power, make sure all speakers, microphones, and other input
devices are connected. Set Master section controls to the 12 o’clock position
and all other controls all the way down (rotated fully to the left). Turn power on
by placing the ON/OFF switch located on the back of the mixer (Fig.11) in the ON
position.
Basic Operation: