User Manual

Escort
®
6000 Specifications:
Output Power: 300 watts RMS (per channel)
Frequency Response: 40 Hz to 20 kHz +/-3 dB
Overload Protection: 10 dB of DDT
™
that limits the PA output to prevent clipping that can damage the speakers
Distortion: Less than 0.2% THD @ Max power
Signal/Noise Ratio: 88 dB mic input typical
AC Power: 115 V AC 60 Hz or
230 V AC 50/60 Hz
Weight Assembled: 50 lbs. (22.67 kg)
(stands included)
Dimensions: 14.5” H x 36.75” W x 15.5” D
(36.8 cm x 93.3 cm x 39.4 cm)
Speakers: Woofer 10” (254 mm)
Piezoelectric Horn Tweeter
Escort
®
6000 Troubleshooting Guide
Problem Check Correction
No sound
(LCD not lit)
Is power switch on?
Is line cord connected to live power outlet?
Turn power switch on
Connect power cord to live outlet
No sound
(LCD lit)
Are MASTER and CHANNEL GAIN controls up? Adjust both MASTER and CHANNEL LEVEL
controls upward to desired level. Check
speaker connections. Turn mic switch on.
Check mic or sound source connection.
No Effects
Files on USB memory device will not
play back
If it goes away when the CHANNEL or MASTER LEVEL
controls are turned down, then it is acoustic feedback.
Make sure desired effect is selected in
Master effect menu. Check the master
EFX MUTE. If the LED is illuminated the
EFX MUTE is active. Press the EFX MUTE
button once to disable. Adjust channel
EFX control until audio effect is heard.
Make sure once MEDIA SELECT knob is
rotated to display desired le the knob
is then pressed to cue the le. Make sure
your audio les are the correct format.
See the list of supported audio formats
mentioned previously in this manual.
Are the channel EFX controls turned up?
Is the master EFX MUTE enabled?
Is an effect activated in menu?
Is the le cued for playback?
Are the audio les the proper format?
Loud howling or squeal
from speakers
Reduce microphone gain. Reposition
microphone behind or farther from
speakers. Observe FLS light above
Graphic EQ and reduce level of
corresponding slider.
Sound is distorted
No sound
(Bluetooth
®
)
Is the CHANNEL GAIN at a very high setting?
Is the “Active” light ashing?
Reduce LEVEL controls accordingly.
Start with CHANNEL LEVEL then adjust
MASTER LEVEL accordingly to achieve
desired volume with no distortion.
Place the Bluetooth/USB switch in the
“Bluetooth” position.
Bluetooth enabled device must be “paired”
before music can be played through the
Escort 6000. Once the device is paired, the
Active LED will light continuously.