TriFlex II ™ Three-way self-powered two-channel sound reinforcement system Operating Manual www.peavey.
Intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. CAUTION: Risk of electrical shock — DO NOT OPEN! CAUTION: To reduce the risk of electric shock, do not remove cover. No user serviceable parts inside.
IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electrical products, basic cautions should always be followed, including the following: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any of the ventilation openings. Install in accordance with manufacturer’s instructions.
TriFlex II ™ ENGLISH Thank you for purchasing the class D powered TriFlex™ II. The TriFlex II is a three-way self-powered two-channel sound reinforcement system. Based on a common subwoofer cabinet with a premium 15” woofer, and a pair of two-way satellite speakers with a 10” heavy-duty woofer and a RX™14 titanium diaphragm dynamic compression driver mounted on a 75° by 75° coverage Quadratic Throat Waveguide™ horn.
Applications The Peavey TriFlex™II System has a variety of applications such as DJ, sound reinforcement, public address, or karaoke. It can even be used as a pair of powered monitors by turning the Subwoofer level all the way down. A typical signal source for the line-level inputs of the Peavey TriFlex II would be a sound reinforcement mixing console (mixer) or the output from a CD player, MP3 player or tape deck.
TOP – OPERATING CONTROLS, INPUTS & OUTPUTS 12 14 5 10 6 7 9 13 11 8 4 GROUND LIFT SWITCH (4) Switches the XLR (7,10) PIN 1 (shield) from direct contact with ground in the event that hum occurs with the input cables connected. Push IN to lift the ground. INPUTS, Left & Right (7,10) The line-level input is of the medium impedance balanced type. Jack (7, 10) is a combo female XLR and 1/4" TRS connector.
instance, you can run a Mono signal to the Left channel input (10), then run a short XLR cable from the Thru jack (11) to the input jack of the Right channel (7). These outputs are buffered (isolated from the input) and set at unity gain, and are not affected by the level control. Whatever the signal level is going into the Inputs, that is the level that comes out.
WHEN USING STANDS OR POLES, BE SURE TO FOLLOW THESE PRECAUTIONS: A. Check the stand or pole specs to make sure that it can support the weight of the TriFlex™ II Satellite (24 lbs./10.9kg), and observe all safety precautions stated by the stand manufacturer, including the maximum height the stand is rated for. B. Always place the stand on a flat, level and stable surface, and be sure to fully extend the stand legs as per the stand manufacturer’s instructions. C.
The amplifiers in the TriFlex™ II are equipped with DDT™ and an LED indicator to show that DDT has engaged (13). If the sound seems heavily compressed, check this indicator; if it is blinking RED more than occasionally, then the drive level from the mixer (or the Level control/s {5,6} on the TriFlex II) needs to be reduced. When first turning on the sound system, switch on all upstream electronics first, then the TriFlex II with its Master System Level control fully counterclockwise (all the way down).
MONOPHONIC OPERATION If mono operation is desired, so that the two channels, and thus, both satellites, play the same signal, see the Monophonic Hook-up Diagram near the end of the manual. TROUBLESHOOTING NO OUTPUT AT ALL First, make sure the unit has AC power and is turned ON. Make sure the LED (13) on the power amp module is illuminated, it should be illuminated green.
excessive additional bass boost or HF boost have been added externally to the TriFlex™ II, it could cause premature overload at high SPL. Reduce the amount of any external (mixer, rack) EQ and see if that clears up the distortion. Finally, realize that even though the TriFlex II is a powerful and high output unit, it does ultimately have limits, and it may need additional powered units to provide enough sound output or coverage.
Triflex II ™ SPECIFICATIONS TRIFLEX™ II SYSTEM SPECIFICATIONS SUBWOOFER Transducer complement: 1 x 15” woofer, custom heavy-duty Nominal Impedance: 8 ohms Power Handling, Transducer: 350W Continuous, 700W Program Sound Pressure Level, 1 Watt, 1 meter in 1 / 2 space environment: 101 dB Right channel 4-pin twist-lock professional connector Output Maximum Sound Pressure Level (1 meter, 1 / 2 space): 124 dB CONTROLS: Weight: 24 lbs. (10.9 kg) Dimensions (H x W x D): 19.6" X 11.83" X 11.
23.500 31.970 28.000 19.820 19.000 11.750 11.750 19.475 19.
TYPICAL STEREO HOOK-UP DIAGRAM Inputs Keyboard 1/4” Phone Jack Cables RCA Phono Cables Guitar XLR Cables CD Player/MP3 Player Mixer Inputs Outputs Dynamic Mic (No Electrets) Mixer XLR Cables D TriFlex II Input/Output Panel Inputs 4 Pin TwistLock To 4 Pin Twist-Lock Speaker Cables Mixer TriFlex II Satellite Speaker TriFlex II Satellite Speaker MINIMALIST STEREO DJ HOOK-UP DIAGRAM (No mic input, just music from signal source.
ellite MONOPHONIC HOOK-UP XLR Cable Inputs Output TriFlex II Input/Output Panel XLR Cable Mixer 4 Pin TwistLock To 4 Pin Twist-Lock Speaker Cables TriFlex II Satellite Speaker TriFlex II Satellite Speaker DAISY CHAIN USE OF MULTIPLE TRIFLEX II SYSTEMS XLR Cables TriFlex II Input/Output Panel Inputs Outputs Mixer 4 Pin TwistLock To 4 Pin Twist-Lock Speaker Cable 4 Pin TwistLock To 4 Pin Twist-Lock Speaker Cable TriFlex II Satellite Speaker TriFlex II Satellite Speaker TriFlex II Input/Output
Features and specifications subject to change without notice. Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian • MS • 39305 (601) 483-5365 • FAX (601) 486-1278 • www.peavey.com • ©2010 Printed in the U.S.A.