Outdoor Speaker System Operation Manual 258 EFX

(14) EFX ADJUST

Pressing this control selects the effect. A yellow LED adjacent to the effect name will

illuminate to indicate the selected effect. Rotating this control clockwise changes the

parameter of the active effect according to the descriptions below. The surrounding LED ring

indicates relative value of the parameter being adjusted.

EFX ADJ PARAMETERS

Tremolo - Rate increase Funk Wah - Sensitivity increase

Octaver - Wet/Dry mix Rotary Speaker - Rate increase

Flanger - Rate increase Phaser - Rate increase

Chorus - Rate increase/depth decrease

EFX amps are built with factory settings loaded into the presets. To return to the factory

settings, press and hold both the EFX ADJUST (14) and DELAY (16) controls while turning

the amp on.

(15) REVERB

This control adjusts the overall reverb level. The surrounding LED ring indicates level.

(16) DELAY

This control adjusts delay type, time, and volume. Three types of delay are available: SLAP (1

repeat), ECHO (3 - 4 repeats), or INFINITE (5 - 6 repeats). The LEDs in each section of the

control indicate which type is active and volume level. Pressing the control twice sets the

delay time to interval between presses.

FOOTSWITCH (NOT INCLUDED)

MODE SELECT

The PFC 3 footswitch operates in two modes: EFX Select mode and Preset Select mode.

Pressing the MODE SWITCH (17) selects between the two modes. The active mode is

indicated by the MODE LED (18). Illumination of the LED indicates EFX Select Mode; a dark

LED indicates Preset Select Mode. Controls and indicators 19-24 perform different functions

relative to the active mode.

EFX SELECT MODE

NOTE: When entering this mode, the current preset will remain active.

In this mode, PRESET 1 (19) selects between the Lead and Clean channels. The CHANNEL

LED (20) will illuminate when the Lead channel is active. PRESET 2 (22) toggles between

two effects and their respective settings. This switch may be used as an on/off switch if one of

the settings has no effects active. To use the MODULATION LED (21) as a status indicator,

the “off” (or lower setting) should be made with the LED dark, and the “on” (or higher setting)

PRESET

PRESET PRESET

MODULATION

CHANNEL

DELAY

REVERB

PFC 3

DOUBLE-CLICK

TO STORE PRESET

EFX

SELECT

MODE

17 18 19 20 21 2322 24