User Manual

LINE VOLTAGE SELECT SWITCH

This selector switch allows the amplier to be operated at dierent line voltages. Please be sure this switch is set to the

proper voltage for your area before connecting the amplier to a power source or turning the amplier on for the rst time.

NEVER CHANGE THE POSITION OF THIS SWITCH WHILE THE AMPLIFIER IS TURNED ON.

CAUTION! THE FUSE MUST BE CHANGED TO THE CORRECT VALUE PRINTED ON THE REAR OF THE CHASSIS IF

A DIFFERENT LINE VOLTAGE IS SELECTED.

SPEAKER OUTPUT JACKS

These combination 1/4" / twist-lock connectors are used to connect speaker cables to the amplier. The minimum load

impedance on the amplier is 4Ω, which means that either a single 4Ω cabinet, or two 8Ω cabinets may be used.

FX LOOP

The eects loop consists of the SEND and RETURN jacks, which are used to patch external eects processors post EQ

in the signal chain. Connect the SEND jack to the input of eects processors. Connect the RETURN jack to the output of

eects processors.

DI PRE/POST SELECT SWITCH

This switch is used to select the DI signal source from either pre or post EQ. Usually, if the DI is used in a live setting to

send signal to a PA system, it’s best to use the PRE EQ setting because the DI signal will not be eected by changing any

of the amplier controls, which allows independent EQ adjustments for the PA system. The POST EQ setting is useful for

recording, connecting the amplier to an external power amplier, or for live use if you run eects processors through the

FX LOOP.

XLR BALANCED DI OUTPUT

This XLR output is used to connect the Mini Max pre amp section to external equipment, such as mixing consoles, external

power ampliers, or recording equipment.

DI GND LIFT SWITCH

This switch may be used to eliminate hum caused by ground loops between the amplier and other equipment, such as a

mixing console.