Operation Manual

COMPRESSOR ON/OFF SWITCH

This button switches the compressor on and off.

VOLUME

This knob controls the overall volume of the amplier.

DDT

™

(Distortion Detection Technique)

This button prevents power amplier clipping that can damage speakers. Although this feature can be

activated or bypassed by this switch, Peavey

recommends the DDT stay enabled for optimum system

performance.

HEADPHONE OUTPUT

1/4" headphone output for personal monitoring.

DDT INDICATOR LIGHT

When DDT is enabled, the Protect/Clip LED will ash when DDT is triggered. This is normal. However,

if the LED is constantly illuminated, the gain level needs to be reduced to prevent possible equipment

damage. When DDT is defeated, the LED becomes a clip indicator. The DDT LED indicator is also a fault

indicator. If the amp is overheating, this LED will light up red and the amp will produce no sound. In this

case, the user needs to stop playing and allow the cooling fan to cool the amp down before continued

use. When the amp has returned to normal operating temperature, the light will turn green again. Also,

the user needs to verify that they are not exceeding the 4 ohm load limit and that the cooling vents are

free from obstruction. The other fault condition is when the output short protection is activated either

by a shorted speaker cable or by exceeding the 4 ohm load limit. If the LED stays red all the time, the

amplier needs to be taken to an authorized Peavey service center immediately for service.

POWER SWITCH

To apply power to the unit, ip the switch to the “ON” position. The green LED will illuminate, indicating

that power is being supplied.

Caution: The Power switch in this unit does not break both sides of the primary mains.

Hazardous energy can be present inside the chassis even when the Power switch is in the

"OFF" position.

AC POWER INLET:

This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to

this connector to provide power to the unit.

Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does

not have a ground pin, a suitable grounding adapter should be used, and the third wire should be

grounded properly. To prevent the risk of shock or re hazard, always make sure that the amplier and

all associated equipment is properly grounded.

Headliner Rear Panel