Operation Manual

19
Tour
™
Series Headliner
™
Head Specications
Tour Series Headliner Head
Features and specifications subject to change without notice.
All specifications tested with mains voltage maintained at nominal level.
NOTE: All specications tested with
mains voltage maintained at nominal
level.
Line Voltage:
100vac to 240vac 50/60 Hz universal
power supply
CAUTION: Do not switch line voltage
while unit is powered on. Doing so may
cause damage to unit.
Typical Power Consumption = 100W
Power Amplier Specications:
Protection:
DDT
™
speaker protection with defeat
switch
Short circuit protection
Thermal protection circuit
Current limit protection circuit
DC output protection circuit
Input Sensitivity (signal into return
jack with master volume set to 5):
7.32 dBu
Power Output:
All measurements with no more than
1% THD + N
8 ohms 200 watts (40.0 VRMS)
4 ohms 300 watts (34.6 VRMS)
Headphone Amplier Specications:
Stereo 8 ohm minimum load
Power Output:
All measurements with no more than
1% THD + N
8 ohms 250 mW (1.41 VRMS) x 2
Preamplier Specications:
Settings for the Following
Measurements (unless stated
otherwise):
PRE GAIN = 5 (12 o’clock)
BRIGHT = out
CONTOUR = out
CRUNCH = out
LOW = 0 (12 o’clock)
HIGH = 0 (12 o’clock)
GRAPHIC EQ = All sliders set to center
GRAPHIC EQ SWITCH = out
COMPRESSION = OUT
POST GAIN = 10 (fully CW)
DDT
™
= Active
Input Sensitivity (input selector set to
passive):
Nominal Input = -17.8 dBu
Minimum Input = -40.9 dBu
Maximum Input = 1.3 dBu (maximum
signal at input before clipping)
Input Sensitivity (input selector set to
active):
Nominal Input = -3.80 dBu
Minimum Input = -31.3 dBu
Maximum Input = 10.2 dBu (maximum
signal at input before clipping)
D.I. XLR Output:
Balanced output driven pre-EQ by
buffered instrument signal Foot
Switch Jack:
Ground switching type, TRS phone
plug (T = compressor, R = crunch, S =
ground)
Weight:
12 lbs. / 5.4 Kg
Dimensions (h x w x d):
(h x w x d): 2.813in / 7.14cm x
17.375in / 44.13cm x 12.500in