Cover for IDC™ 150TII 1
Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. CAUTION: Risk of electrical shock – DO NOT OPEN! CAUTION: To reduce the risk of electric shock, do not remove cover. No user serviceable parts inside.
IDC™ 150TII TM ® Congratulations on your purchase of the IDC™ 150TII. The IDC™ 150TII power amplifier is a three rack space, solid state, mono power amplifier capable of delivering more than 150 W RMS. The unit has been designed to be reliable, meeting the needs of most fixed installation applications. One of the most significant features of this amplifier is its battery backup capability. This amplifier will operate with a 24 V DC external power source as well as 120 V AC power.
Rear Panel: BACK PANEL FEATURES: FUSE (6) WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN DISCONNECTED FROM ITS POWER SOURCE. CAUTION: USING A FUSE LARGER THAN THE RECOMMENDED SIZE COULD RESULT IN PERMANENT DAMAGE TO THE AMPLIFIER. The fuse is located within the cap of the fuseholder. If the fuse should fail, IT MUST BE REPLACED WITH THE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT VOIDING THE WARRANTY.
INSTALLATION INFORMATION: POWER HANDLING AND GROUNDING For your safety, we have incorporated a 3-wire line (mains) cable with proper grounding facilities. It is not advisable to remove the ground pin under any circumstances. If it is necessary to use the equipment without proper grounding facilities, suitable grounding adapters should be used. Less noise and greatly reduced shock hazard exists when the unit is operated with the proper grounded receptacles.
SPECIFICATIONS (all measurements @ 120 V AC, 60 Hz or 24 V DC) Rated Output Power: (typical value) AC powered, continuous sine wave: 70 volt line 32.7 ohms, 1 kHz, 1% THD: 150 W RMS 25 volt line 4.2 ohms, 1 kHz, 1% THD: 150 W RMS Input Sensitivity: (FCW attenuator setting) 150 W RMS, rated output power Input voltage: 1.1 V RMS 24 V DC battery powered, continuous sine wave: 70 volt 32.7 ohms, 1 kHz, 1% THD: 100 W RMS 25 volt 4.
IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electric products, basic cautions should always be followed, including the following: 1. Read all safety and operating instructions before using this product. 2. All safety and operating instructions should be retained for future reference. 3. Obey all cautions in the operating instructions and on the back of the unit. 4. All operating instructions should be followed. 5. This product should not be used near water, i.e.
