Users Manual

7
Rear Panel
16
15
14
T5 AL/250V 100-240V
~ 50/60Hz
FUSE
Power Consumption : 40W
Consumo de energia 40Wh
M/N: LN1063
Electronics Corp.
Peavey
LN1063
Peavey Electronics Corp.
5022 Hartley Peavey Drive
Meridian, MS 39305
[phone]
www.peavey.com
POWER
CH1
AUX
PAIR
POWER/LIMIT
CH2 CH3/4 CH5/6 MASTER
REVERB
ON
Designed and Engineered in U.S.A.
Made in China
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
--Apparatets stikprop skal tilsluttes en stikkontakt med jord,
som giver forbindelse til stikproppens jord. (For Denmark Only)
--Laite on liitettävä suojamaadoituskoskettimilla varustettuun
pistorasiaan. (For Finland Only)
--Apparatet må tilkoples jordet stikkontakt. (For Norway Only)
--Apparaten skall anslutas till jordat uttag. (For Sweden Only)
CAUTION
AVIS:
VASES, SHOULD NOT BE PLACED ON THIS APPARATUS.
TO REDUCE THE RISK OF FIRE OR ELECTRIC
WARNING:
SHOCK, THIS APPARATUS SHOULD NOT BE EXPOSED TO RAIN
OR MOISTURE AND OBJECTS FILLED WITH LIQUIDS, SUCH AS
REMPLI DE LIQUIDE, TEL QU’UN VASE, NE DOIT ETRE POSE
SUR CELUI-CI.
DANS LE BUT DE REDUIRE LES RISQUES D’INCENDIE
OU DE DECHARGE ELECTRIQUE, CET APPREIL NE DOIT PAS
ETRE EXPOSE A LA PLUIE OU A L’HUMIDITE ET AUCUN OBJET
AVIS:
RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
REVERB
MIN MAXMIN MAX
LEVEL
MIN MAX
HIGH
-12 +12
LOW
-12 +12
LEVEL
MIN MAX
HIGH
-12 +12
LOW
-12 +12
LEVEL
MIN MAX
LEVEL
MIN MAX
LEVEL
MIN MAX
HIGH
-12 +12
LOW
-12 +12
I4S-LN1063
3642A-LN1063
(14) Power Switch
e power switch is used to turn the speaker on and o
(15)Fuse
is is the main safety fuse for the AC line voltage. Only replace with a fuse of the exact type and rating. If the
fuse continues to fail, do not replace the fuse again. Take the unit to an authorized Peavey service center.
(16) AC Power Inlet
is is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to
this connector to provide power to the unit. Damage to the equipment may result if improper line voltage is
used. (See line voltage marking on unit).
Never break o the ground pin on any equipment. It is provided for your safety. If the outlet used does not
have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded
properly. To prevent risk of shock or re hazard, always make sure that the amplier and all associated
equipment is properly grounded.