Operation Manual

Rear Panel

THE BOTTOM LINE: using the effect will make the lowest notes you can possibly play sound unbeliev-

ably loud and clear. Practice with headphones is no longer a compromise. It even works with chords!

HINT: For best results, try using the effect without boosting the LOW control to extreme settings. This

will make the effect more apparent.

VOLUME

This knob controls the overall volume of the amplier.

TUNE/MUTE

Pressing this button will engage the chromatic tuner while muting the output to the speaker. The LED

screen will indicate which note is being played while the red and green LEDs above the screen indicate

whether the note is at (red), sharp (red) or in tune (green). This switch also mutes the DI.

AUX INPUT

This 1/8" input jack allows you to connect a CD player or MP3 player to your MAX Series bass amp

and play along

HEADHPHONE OUTPUT

1/8" headphone output for personal monitoring.

POWER SWITCH/DDT

™

INDICATOR LIGHT

This dual-purpose switch is used to turn the amp on and off. When the DDT (Distortion Detection

Technique) senses power amp clipping, a protection circuit is engaged and the LEDs in the power switch

change to red.

CAUTION: The on/off switch in this unit does not break both sides of the primary mains. Hazardous

energy can be present inside the chassis even when the on/off switch is in the OFF position.

AC POWER INLET:

This is the receptacle for an IEC line cord, which provides AC power to

the unit. Connect the line cord to this connector to provide power to the

unit. Damage to the equipment may result if improper line voltage is

used. (See line voltage marking on unit).

Never break off the ground pin on any equipment. It is provided for

your safety. If the outlet used does not have a ground pin, a suit-

able grounding adapter should be used, and the third wire should be

grounded properly. To prevent the risk of shock or re hazard, always

make sure that the amplier and all associated equipment is properly

grounded.

NOTE: FOR UK ONLY

As the colors of the wires in the mains lead of this apparatus may not correspond with the colored mark-

ings identifying the terminals in your plug, proceed as follows: (1) The wire that is colored green and yel-

low must be connected to the terminal that is marked by the letter E, or by the Earth symbol, or colored

green or green and yellow. (2) The wire that is colored blue must be connected to the terminal that is

marked with the letter N, or the color black. (3) The wire that is colored brown must be connected to the

terminal that is marked with the letter L, or the color red.